• Line array column speaker, built-in single-channel audio amplification power module;
  • Module with closed ultra-quiet fanless design;
  • POE power supply drive work;
  • With RJ45 interface, Dante transmission protocol, which can receive Dante digital audio to decode it for sound reinforcement;
  • With 5-band PEQ adjustment, parameter presetting, channel gain and mute control;
  • Support network remote discovery and control;

Speaker Parameters

  • Speaker type POE active
  • Amplify technology SSA
  • Input interface Single RJ-45, supports standard Dante signal input
  • Transmission protocol Dante
  • System type LF:8×3″(1″voice coil)
  • Frequency response range 105Hz~16KHz(±3dB)
  • Maximum sound pressure level 117dB@1m
  • Sensitivity (1W / 1m) 91dB
  • Continuous power 100W AES
  • Impedance 8 Ω
  • Power supply PoE +, compatible with 802.3af, compatible with 802.3at
  • Coverage angle (HxV) 100°x10°
  • Size (mm) 160Dx100Wx100H
  • Crossover Frequency Full frequency

Built-in Power Module Parameters

  • Frequency response rang 20Hz – 20kHz
  • Number of channels 1
  • Audio input type Dante
  • Input connector Single RJ-45
  • Maximum power output 60W/8Ω、100W/4Ω(peak value)
  • System power efficiency >70%
  • Output connector 3 pin Phoenix Block
  • Routing control Dante Controller
  • Audio parameter control Redx-D-Controller
  • Signal to noise ratio >100dB(A-weighted)
  • Background noise <130uV
  • Power input mode PoE +, compatible with 802.3af, compatible with 802.3at



Brochure – DynePro – Commercial Series

Brochure – DynePro – Conferencing Series

Datasheet – DA-RPOCL8