DA-RPO65

Features Parameters Diagrams Downloads

Features

6.5-inch coaxial ceiling speaker, built-in single-channel audio amplification power module;
Module with closed ultra-quiet fanless design;
POE power supply drive work;
With RJ45 interface, Dante transmission protocol, which can receive Dante digital audio to decode it for sound reinforcement;
With 5-band PEQ adjustment, parameter presetting, channel gain and mute control;
Support network remote discovery and control;

Speaker Parameters

Speaker type POE active
Amplify technology SSA
Input interface Single RJ-45, supports standard Dante signal input
Transmission protocol Dante
System type 1 X 6.5″+3 X 0.5″ coaxial unit
Frequency response range 75Hz-20KHz(±3dB)
Maximum sound pressure level 108dB
Sensitivity (1W / 1m) 92dB
Continuous power 30W
Impedance 8 Ω
Power supply PoE +, compatible with 802.3af, compatible with 802.3at
Coverage angle (HxV) 90°x90°
Size (mm) Φ240×220

Built-in Power Module Parameters

Frequency response rang 20Hz – 20kHz
Number of channels 1
Audio input type Dante
Input connector Single RJ-45
Maximum power output 21W/8Ω
System power efficiency >70%
Output connector 3 pin Phoenix Block
Routing control Dante Controller
Audio parameter control Redx-D-Controller
Signal to noise ratio >100dB（A-weighted）
Background noise <200uV
Power input mode PoE +, compatible with 802.3af, compatible with 802.3at

Diagrams

Downloads

Brochure – DynePro – Commercial Series

Brochure – DynePro – Conferencing Series

Datasheet – DA-RPO65

COPYRIGHT 2017 Danacoid International, ALL RIGHT RESERVED
Terms & Condition | Privacy Policy | Disclaimer